CRUX SWRFD-60 Manual

Read below 📖 the manual in Italian for CRUX SWRFD-60 (3 pages) in the Not categorized category. This guide has been helpful for 24 people and has been rated 4.5 stars on average by 2 users

Page 1/3
SWRFD-60
SWRFD-60 Module SWRFD-60 Harness SWC Cable Antenna Adapter
Radio Replacement Interface with SWC Retention
for Amplied and Non-Amplied FORD, LINCOLN & MERCURY
R
INTERFACING SOLUTIONS
Sightline
Multi View Integration
A 91311
1 of 7
PRODUCT FEATURES:
INSTALLATION DIAGRAM FOR AMPLIFIED VEHICLES:
rev. 032625
16 -Pin Black
Connector
AFTERMARKET
RADIO
TO FACTORY
HARNESS
4-Pin
Connector
Cap or insulate if
not being used
Kenwood/JVC (BLUE /YELLOW)
Insulate with tape
if not used
3.5MM SWC CABLE
Plug in the 3.5MM SWC cable to the 4-pin port
on the module. See below for DIP switch settings.
AFTERMARKET
RADIO SELECTOR
(See Page 3)
FORD
SWC SWITCHES
(NOT USED)
RADIO VEHICLE
1 2 3 4 5 6
INTERFACING SOLUTIONS
Yellow
Red
Black
Gray
Gray/Black
White
White/Black
Violet
Violet/Black
Green
Green/Black
Brown/ White
Orange
Blue/White
Purple/White
Pink
Blue
Green/White
12V Constant
+12V ACC
Ground
Right Front (+)
Right Front (-)
Le Front (+)
Le Front (-)
Right Rear (+)
Right Rear (-)
Le Rear (+)
Le Rear (-)
Parking Brake
Illuminaon
Amp Turn on
Reverse Gear
VSS
Power Antenna
SWC Phone
Rear Seat Entertainement
*Subwoofer
To SYNC/APIM Module
**Center
Aux Input
24-Pin
Plug
16-Pin
Plug
8-Pin
Plug
Subwoofer
Converter
Module
PARTS INCLUDED:
Works with Amplied and Non-Amplied For, Lincoln and Mercury vehicles
Retains Factory-installed Subwoofer.
Retains Steering Wheel Controls via builtin, pre-programmed interface.
With navigation outputs (Reverse gear, Illuminstion, Speed signal and Parking brake)
Provides Accessory Power (2A MAX).
Retains factory Aux and rear seat entertainment inputs.
Supports Sony, Shaker, THX and non amplied sound systems.
*Connect the white subwoofer RCA jack to the subwoofer output on the aftermarket radio.
If the vehicle is equipped with a center channel speaker (located on the dashboard), connect the red center
channel RCA jack to the center channel output of the aftermarket radio.
Note: If the aftermarket radio has limited RCA outputs, a 1 male to 2 female (1M2F) RCA splitter may be required.
A 91311
.cruxinterfacing.com
2 of 7
R
INTERFACING SOLUTIONS
Sightline
Multi View Integration
INSTALLATION DIAGRAM FOR NON-AMPLIFIED VEHICLES:
SWRFD-60
rev. 032625
Green RCA (Left Rear)
Gray RCA (Right front)
White RCA (Left front)
Violet RCA (Right Rear)
Right Front (+)
Right Front (-)
Left Front (+)
Left Front (-)
Right Rear (+)
Right Rear (-)
Left Rear (+)
Left Rear (-)
GRAY
GRAY/BLACK
WHITE
WHITE/BLACK
VIOLET
VIOLET/BLACK
GREEN
GREEN/BLACK
*
For Non-Amplied systems please cut RCA , and mate colored wires
to the appropriate aftermarket radio speaker wires
To SYNC/APIM Module
16 -Pin Black
Connector
AFTERMARKET
RADIO
TO FACTORY
HARNESS
4-Pin
Connector
Cap or insulate if
not being used
Kenwood/JVC (BLUE /YELLOW)
Insulate with tape
if not used
3.5MM SWC CABLE
Plug in the 3.5MM SWC cable to the 4-pin port
on the module. See below for DIP switch settings.
AFTERMARKET
RADIO SELECTOR
(See Page 3)
FORD
SWC SWITCHES
(NOT USED)
RADIO VEHICLE
1 2 3 4 5 6
INTERFACING SOLUTIONS
Yellow
Red
Black
Gray
Gray/Black
White
White/Black
Violet
Violet/Black
Green
Green/Black
Brown/ White
Orange
Blue/White
Purple/White
Pink
Blue
Green/White
12V Constant
+12V ACC
Ground
Right Front (+)
Right Front (-)
Le Front (+)
Le Front (-)
Right Rear (+)
Right Rear (-)
Le Rear (+)
Le Rear (-)
Parking Brake
Illuminaon
Amp Turn on
Reverse Gear
VSS
Power Antenna
SWC Phone
Rear Seat Entertainement
*Subwoofer
**Center
Aux Input
24-Pin
Plug
16-Pin
Plug
8-Pin
Plug
Subwoofer
Converter
Module
Radio Replacement Interface with SWC Retention
for Amplied and Non-Amplied FORD, LINCOLN & MERCURY
*If the vehicle is equipped with a factory subwoofer, connect the white subwoofer RCA jack to the subwoofer
output on the aftermarket radio.
The red center channel RCA jack is not used in this application
A 91311
.cruxinterfacing.com
3 of 7
R
INTERFACING SOLUTIONS
Sightline
Multi View Integration
SWRFD-60
rev. 032625t
DIP SWITCH SETTINGS:
AFTERMARKET RADIO DIP SWITCH SETTINGS:
RADIO BRAND: DIP#: 1 2 3
Atoto, Dual, Fahrenheit, Jensen, Nakamichi,
Pioneer, Power Acoustik, Soundstream
Alpine
Clarion
Kenwood
JVC
Boss, Old Sony
New Sony (with CarPlay)
OFF ON ON
OFF ON ON
OFF ON ON
OFF OFF OFF
ON ON OFF
ON ON ON
ON OFF ON
ON OFF OFF
OFF ON OFF
SWC MODULE
DIP SWITCH
1 2 3
ON
4 5 6
NOTE:
radios, check the aftermarket radio’s manual to see if the SWC buttons need to be programmed.
4-PIN SWC CABLE
RED to SWC Key 1
WHITE to SWC Key 2
SHIELD to SWC Ground
SWC Troubleshoot option
Located internally
Need to take plastic
Casing o module
• If Steering Wheel Controls don’t
work or work properly please switch
internal dip switch from 3v3 to 5v
as shown in picture above.
NOTE:
DIP SWITCHES
4 - 6 ARE NOT
USED
Radio Replacement Interface with SWC Retention
for Amplied and Non-Amplied FORD, LINCOLN & MERCURY

Product Specifications

Brand: CRUX
Category: Not categorized
Model: SWRFD-60

Do you need help?

If you need help with CRUX SWRFD-60, ask a question below and other users will answer you




Not categorized CRUX User Manuals

CRUX

CRUX SWRFD-60T Manual

19 October 2024
CRUX

CRUX SWRFD-60B Manual

13 October 2024
CRUX

CRUX SOOGM-16K Manual

13 October 2024
CRUX

CRUX SOCGM-17B Manual

13 October 2024
CRUX

CRUX DKGM-49 Manual

13 October 2024
CRUX

CRUX DKGM-C2S Manual

13 October 2024
CRUX

CRUX DKVW-21 Manual

13 October 2024
CRUX

CRUX SOHTL-20 Manual

13 October 2024
CRUX

CRUX AVIGM-04S Manual

13 October 2024
CRUX

CRUX SOCVW-21 Manual

13 October 2024

Not categorized User Manuals

Latest Not categorized User Manuals