CRUX SWRTY-61J Manual

CRUX Not categorized SWRTY-61J

Read below 📖 the manual in Italian for CRUX SWRTY-61J (5 pages) in the Not categorized category. This guide has been helpful for 23 people and has been rated 4.5 stars on average by 2 users

Page 1/5
SWRTY-61J
Radio Replacement with Steering Wheel Control Retention for
LEXUS & TOYOTA Vehicles with JBL Systems
Crux Interfacing Solutions • Chatsworth, CA 91311
phone: (818) 609-9299 • fax: (818) 996-8188 • www.cruxinterfacing.com
RAD REPLA TIO CEM EN
SWC ENTRE T ION
+
R
PRODUCT FEATURES:
- Pre-programmed to retain factory Steering Wheel Controls.
- Retains factory backup camera (if present).
- Retains OEM 3.5mm Auxiliary Audio Input.
- Supports Pick Up/End Call, Pick up and Toggle between 1st and 2nd incoming call, AVRCP Track, Seek.
removing the radio.
PARTS INCLUDED:
SWRTY-61J Module TY-A Harness
(For Newer Models)
TY-B Harness
(For Older Models)
3.5MM to 4-pin SWC Cables
16 to 24 Pin Camera Adapter
IMPORTANT INSTALLATION NOTES:
rev.090924
1 of 6
NOTES:
Crux Interfacing Solutions • Chatsworth, CA 91311
phone: (818) 609-9299 • fax: (818) 996-8188 • www.cruxinterfacing.com
RAD REPLA TIO CEM EN
SWC ENTRE T ION
+
R
rev.090924
INSTALLATION DIAGRAM:
SWRTY-61J
Radio Replacement with Steering Wheel Control Retention for
LEXUS & TOYOTA Vehicles with JBL Systems
2 of 6
AFTERMARKET
RADIO
SWRTY-61J MODULE
1 2 3
ON
1 2 3
ON
AFTERMARKET
RADIO SELECTOR
(See Chart)
GAIN
ADJUSTMENT
+12V Constant Yellow
+12V ACC Red
Ground Black
Illumination Output Orange
Amp Turn-On Blue/ White
Antenna Turn On Blue
Vehicle Speed Sense Output
Red/Black or Pink
Parking Brake Output Brown
Reverse Gear Output Red
Right Front + Gray
Right Front - Gray/Black
Left Front + White
Left Front - White/Black
Audio Input Red/White RCA
(Retains Factory AUX Input)
12-Pin Black
Connector
Cap or insulate if
not being used
BLUE / YELLOW KENWOOD / JVC SWC WIRED
3.5MM SWC CABLES (Option A or B)
Use the proper 3.5MM to 4-Pin cable for your radio.
Plug in the selected 3.5MM SWC cable to the 4-pin port
on the SWRTY-61J module.
Insulate with tape
if not being used
From SWRTY-61J Harness
To SWRTY-61J Module
SWRTY-61J Module
To Aftermarket Radio Camera Input
To 2 Pin Camera Power Connector
on SWRTY-61J Harness
SWRTY-61J OEM Camera Retention Harness
+12V Constant Yellow
+12V ACC Red
Ground Black
Illumination Output Orange
Amp Turn-On Blue/ White
Antenna Turn On Blue
Right Front + Gray
Right Front - Gray/Black
Left Front + White
Left Front - White/Black
Audio Input Red/White RCA
(Retains Factory AUX Input)
To SWRTY-61J Module
RADIO REPLACEMENT MODULE
TOYOTA
www.cruxint
erfacing.com
SWCGAIN
AFTERMARKET
RADIO
TY-B
Harness
TY-A
Harness
SWRTY-61J OEM Camera
Retention Harness
(See Below)
Yellow RCA
(To Aftermarket Radio Camera Input)
To 24-Pin OEM
Camera Harness
16 to 24 Pin Camera Adapter
The SWRTY-61J includes a camera harness with a 12V to 6V voltage converter to retain the OEM camera (if equipped).
Some older models use a16-Pin OEM camera connector. In this case, use the supplied 16 to 24-Pin Camera Adapter.
24-Pin
Option A:
Alpine, Clarion, JVC and Kenwood units
Option B:
Blaupunkt, Boss, Dual, Farenheit, Jensen, Pioneer,
NOTE: Aftermarket radio rear speaker output leads are not used on both harnesses. Insulate with tape.
Crux Interfacing Solutions • Chatsworth, CA 91311
phone: (818) 609-9299 • fax: (818) 996-8188 • www.cruxinterfacing.com
RAD REPLA TIO CEMEN
SWC ENTRE T ION
+
R
rev.090924
SWRTY-61J
Radio Replacement with Steering Wheel Control Retention for
LEXUS & TOYOTA Vehicles with JBL Systems
3 of 6
SETTING THE AFTERMARKET RADIO BRAND
This step is done on the SWRTY-61J Module. With the key in the off posion,
set the DIP switches to the corresponding radio listed below.
4-PIN SWC CABLE
OPTION A is used for ALPINE, CLARION. For JVC and KENWOOD use the Blue/Yellow wire.
OPTION B is used for ATOTO, BLAUPUNKT, BOSS, DUAL, FARENHEIT, JENSEN, POWER ACOUSTIK,
NOTE: Cap or insulate the 3.5mm plug or Blue/Yellow wire if not being used.
VEHICLE SETTING AND GAIN ADJUSTMENTS:
DIP SWITCH SETTINGS:
RADIO BRAND: DIP: 1 2 3
1 2 3
ON
1 2 3
ON
AFTERMARKET
RADIO SELECTOR
SWRTY-61J
Module
Atoto, Dual, Fahrenheit, Jensen, Pioneer
Power Acoustik, Soundstream
Blaupunkt, Most obrand Radios
Alpine
Clarion
Kenwood
JVC
Sony, Boss
OFF ON ON
OFF ON ON
OFF ON ON
OFF OFF OFF
ON ON OFF
ON ON ON
ON OFF ON
ON OFF OFF
NOTE:
check the aftermarket radio’s manual to see if the SWC buttons need to be pro ammed.gr
RED to SWC Key 1
WHITE to SWC Key 2
SHIELD to SWC Ground
SWC wires as follows:
For aermarket radios that have wires for SWC connecons, cut off the 3.5mm plug on the CRUX SWC Cable and connect the
Note that there are some radios that only ha e SWC1 and SWC2, in this case “shield” does not need to be connected.v
Use the gain adjustment to level match
the aermarket radio audio output with
the OE amplifier input.
Please set pin 1 to the OFF posion
for Toyota vehicles
SELECTING VEHICLE TYPE
SWC Troubleshoot option
Located internally
Need to take plastic
• If Steering Wheel Controls don’t
work or work properly please switch
internal dip switch from 3v3 to 5v
as shown in picture above.
DIP SETTING
Posion 2 3
dB Volts
OFF OFF
OFF ON
ON OFF
ON ON
0 dB
3.5 dB
9.1 dB
12.9 dB
+9mV
+0mV
+18mV
+27mV
1 2 3
ON
1 2 3
ON
SWRTY-61J
MODULE
GAIN
ADJUSTMENT
VEHICLE
SETTING
• Some Blaupunkt use DIP Switch setting OFF ON OFF

Product Specifications

Brand: CRUX
Category: Not categorized
Model: SWRTY-61J

Do you need help?

If you need help with CRUX SWRTY-61J, ask a question below and other users will answer you




Not categorized CRUX User Manuals

CRUX

CRUX SWRFD-60T Manual

19 October 2024
CRUX

CRUX SWRFD-60B Manual

13 October 2024
CRUX

CRUX SOOGM-16K Manual

13 October 2024
CRUX

CRUX SOCGM-17B Manual

13 October 2024
CRUX

CRUX DKGM-49 Manual

13 October 2024
CRUX

CRUX DKGM-C2S Manual

13 October 2024
CRUX

CRUX DKVW-21 Manual

13 October 2024
CRUX

CRUX SOHTL-20 Manual

13 October 2024
CRUX

CRUX AVIGM-04S Manual

13 October 2024
CRUX

CRUX SOCVW-21 Manual

13 October 2024

Not categorized User Manuals

Latest Not categorized User Manuals