Drayton Digistat+C RF Manual

Drayton Thermostat Digistat+C RF

Read below 📖 the manual in Italian for Drayton Digistat+C RF (2 pages) in the Thermostat category. This guide has been helpful for 17 people and has been rated 4.5 stars on average by 2 users

Page 1/2
Models:
13616/13618/13619
Models:
13616/13618/13619
Default Settings
The maximum and minimum setpoints are preset in the factory to
65
o
C and 60
o
C respectively.
Simple Setting or Operating
To set the required temperature
• The display normally shows the current setpoint.
• To adjust the required temperature, turn the
dial clockwise to increase or anti-clockwise to
decrease, (1 click = 5ºC), the LCD will display
the temperature setpoint as it is being
adjusted and ‘SET’ will be displayed. After a
few seconds the display will return
to normal
operation and will display the current setpoint.
DHW Cylinder Thermostat
To assist with commissioning or checking the system operation,
there is a positive OFF setting outside the temperature scale on the
cylinder thermostat. First adjust the minimum temperature setting
to 40
o
C as described in the user guide, then rotate the dial fully
anticlockwise for OFF.
‘Boost 1 Hr’
Digistat+C RF
Digistat+C RF
Digistat+C RF should now display the ‘E and2’ the RF symbol ‘ If’.
Digistat+C RF
Digistat+C RF
Digistat+C RF
Digistat+C RF
the
Digistat+C RF transmitter unit and sensor can be installed.
When the sensor is wired to the transmitter unit, the display will
change after approx. 30 seconds to show the current setpoint and
‘E2’ will disappear
Digistat+C RF
Boost 1 Hr
BOILER
30cm Min
Preferred side of boiler
The range may be affected by
composition/density and number of walls
between the Digistat +CRF and SCR
230V a.c.
230V a.c.
Digistat+C RF
Heating
Radio Signal Range:
30m Typically
SCR
Digistat
+
CRF Digistat
+
CRF
ON
RECEIVE / ALARM
OVERRIDE
LEARN
MODE
1
2
Wireless System
Digistat
+
C SCR
Technical Helpline Tel: 0333 000 6226
www.draytoncontrols.co.uk
Email: customer.care@draytoncontrols.co.uk
Technical Helpline Tel: 0333 000 6226
www.draytoncontrols.co.uk
Email: customer.care@draytoncontrols.co.uk
The hot water can be manually switched on and off by using the
‘Boost 1 Hr’ button on the SCR in a fault situation, even though
the red LED will stay on until a satisfactory signal is reinstated.
When the hot water is turned on by pressing the ‘Boost 1 Hr’
button, it will time out after 1 hour and return to OFF.
the unit.Digistat+C RF
the unit areDigistat+C RF
the Digistat+C RF
the Digistat+C RF
Proper Battery Recycling
Electronic devices and batteries, rechargeable or not, should not be
disposed of into ordinary household waste. Instead, they must be
recycled properly to protect the environment and cut down the waste
of precious resources. Your local waste management authority can
supply details concerning the proper disposal of batteries.
In compliance with the EU Directive 2006/66/EC, the button cell
battery located on the printed circuit board inside this product, can be
removed at the end of product life, by professional personnel only.
Unclip the housing to show the terminal block. First, connect a 2-core
cable to the transmitter, cut to the required length to Digistat+C RF
reach the sensor position. Connect to the sensor in the position shown
and fold wires back through the cable grip & out through the cable
entry, re-assemble the housing.
Signal Strength
Before fixing the to the wall it is recommended to first Digistat+C RF
check the signal strength from that location.
To do this, remove the batteries, press and hold the ‘set’ button whilst
refitting the batteries, keep the ‘set’ button held and after a few
seconds the display will show ‘rF’ which indicates that the Digistat+C RF
is continuously sending an OFF signal to the SCR (receiver). Leave the
Digistat+C RF in position and return to view the SCR. If the red LED is
continuously flashing, this indicates a good signal. If the red LED is not
flashing, this indicates a poor signal and you need to reposition the
Digistat+C RF until the red LED is flashing.
When the signal strength has been confirmed remove the batteries to
cancel the test and follow the installation instructions.
Relevant EC Directives:
Applied Standards:
230V a.c.
of walls between the Digistat +C RF and SCR.
+0/-8
230V a.c.
24V a.c./d.c.
(BS7671).
2014 3 U/5 /E RE DirectiveD
2006/66/EC Battery Directive
EN60730-1; EN60730-2-9
ETSI EN 300 220-3, ETSI EN 301 489-3
2011/65/EU RoHS Directive
Temperature Range: 40°C to 70°C
Industry Standard Wallplate
2
A
2.5Kv
75°C
Mounting:
Pollution Degree:
Software Class:
Pollution Degree:
Software Class:
Rated Impulse Voltage:
Ball Pressure Test:
2
A
Energy Class:
I = 1% (According to EU 811/2013,
812/2013, 813/2013, 814/2013)
401Southway Drive
Plymouth
PL6 6QT
United Kingdom
Drayton Controls reserve the right
to make changes without notice
and cannot accept liability for errors.
401Southway Drive
Plymouth
PL6 6QT
United Kingdom
Drayton Controls reserve the right
to make changes without notice
and cannot accept liability for errors.
Hereby, U , declares that this RF Schneider Electric Controls K Ltd
Cylinder Thermostat is in compliance with the essential
requirements and other relevant provisions of RED-DIRECTIVE
2014/53/EU. Declaration of conformity can be downloaded on:
www.draytoncontrols.co.uk
Softare version:
Maximum
Radiated Power:
6712041
+ dBm ( .6mW)7.5 5
Schneider Electric
Schneider Electric
35 Rue Joseph Monier
France- 92500 Rueil
Malmaison
se.com/contact
Schneider Electric
Schneider Electric
35 Rue Joseph Monier
France- 92500 Rueil
Malmaison
se.com/contact

Product Specifications

Brand: Drayton
Category: Thermostat
Model: Digistat+C RF

Do you need help?

If you need help with Drayton Digistat+C RF, ask a question below and other users will answer you




Thermostat Drayton User Manuals

Drayton

Drayton Digistat+3RF Manual

18 October 2024
Drayton

Drayton RTS4 Manual

18 October 2024
Drayton

Drayton RTS9 Manual

18 October 2024
Drayton

Drayton HTS3 Manual

13 October 2024

Thermostat User Manuals

Latest Thermostat User Manuals

Heatmiser

Heatmiser PRT-ETS Manual

25 October 2024
Heatmiser

Heatmiser PRT-W Manual

25 October 2024
Heatmiser

Heatmiser PRTHW Manual

25 October 2024
Heatmiser

Heatmiser PRT-EWTS Manual

25 October 2024
Heatmiser

Heatmiser DT-N Manual

25 October 2024
Heatmiser

Heatmiser DT-EW Manual

25 October 2024
Heatmiser

Heatmiser PRTHW-WTS Manual

25 October 2024
Heatmiser

Heatmiser PRT-RPTS Manual

25 October 2024
Heatmiser

Heatmiser PRT-RP Manual

25 October 2024
Heatmiser

Heatmiser PRT-B Manual

25 October 2024