Kicker KXA400.4 Manual
Read below š the manual in Italian for Kicker KXA400.4 (32 pages) in the Receiver category. This guide has been helpful for 25 people and has been rated 4.5 stars on average by 2 users
Page 1/32
KXA400.2 | KXA1200.2
KXA400.4
Manual del Propietario | EspaƱol
AMPLIFICADOR DEL LA SERIE KX.2
Benutzerhandbuch | Deutsch
STEREOVERSTĆRKER DER KX.2-SERIE
Manuel dāutilisation | FranƧaise
AMPLIFICATEUR DE SĆRIE KX.2
KX
AMPLIFIERS
Ownerās Manual
2017 KXA Stereo Amps Rev H.indd 12017 KXA Stereo Amps Rev H.indd 1 7/13/2017 12:15:05 PM7/13/2017 12:15:05 PM
2
KX.2-SERIES AMPLIFIERS
OWNERāS MANUAL
INSTALLATION
Mounting: Choose a structurally sound location to mount your KICKER ampliļ¬ er. Make sure there are no
items behind the area where the screws will be driven. Choose a location that allows at least 4ā (10cm)
of open ventilation for the ampliļ¬ er. If possible, mount the ampliļ¬ er in the climate-controlled passenger
compartment. Drill four holes using a 7/64ā (3mm) bit and use the supplied #8 screws to mount the
ampliļ¬ er.
Wiring: Disconnect the vehicleās battery to avoid an electrical short. Then, connect the ground wire to the
ampliļ¬ er. Make the ground wire short, 24ā (60cm) or less, and connect it to a paint-and-corrosion-free,
solid, metal area of the vehicleās chassis. Adding an additional ground wire of this same gauge (or larger)
between the batteryās negative post and the vehicle chassis is recommended.
PERFORMANCE
MODEL: KXA400.2 | KXA1200.2 | KXA400.4
IMPORTANT SAFETY WARNING
PROLONGED CONTINUOUS OPERATION OF AN AMPLIFIER, SPEAKER, OR SUBWOOFER
IN A DISTORTED, CLIPPED OR OVER-POWERED MANNER CAN CAUSE YOUR AUDIO
SYSTEM TO OVERHEAT, POSSIBLY CATCHING FIRE AND RESULTING IN SERIOUS
DAMAGE TO YOUR COMPONENTS AND/OR VEHICLE. AMPLIFIERS REQUIRE UP TO 4
INCHES (10CM) OPEN VENTILATION. SUBWOOFERS SHOULD BE MOUNTED WITH AT
LEAST 1 INCH (2.5CM) CLEARANCE BETWEEN THE FRONT OF THE SPEAKER AND ANY
SURFACE.
Model: KXA400.2 KXA400.4 KXA1200.2
RMS Power
@ 14.4V, 4ī stereo, ā¤ 1% THD+N
@ 14.4V, 2ī stereo, ā¤ 1% THD+N
@ 14.4V, 4ā¦ mono, ā¤ 1% THD+N
100 x 2
200 x 2
400 x 1
50 x 4
100 x 4
200 x 2
300 x 2
600 x 2
N/A
Length [in, cm] 9-9/16, 24.4 11-3/16, 28.4 11-3/16, 28.4
Speciļ¬ cations common to all models:
Height [in, cm] 2-1/8, 5.5
Width [in, cm] 8-5/16, 21
Frequency Response [Hz] 10Hzā20kHz
Signal-to-Noise Ratio [dB] 95dB
Input Sensitivity 250mVā10V
Selectable Electronic Crossover Off; Variable HP, 10ā500Hz; Variable LP, 40ā500Hz;
400Hzā5,000Hz with 10X Switch (bandpass capable);
Slope: 24dB/octave"
KickEQā¢ Bass Boost 0ā18dB @ 40Hz
2017 KXA Stereo Amps Rev H.indd 22017 KXA Stereo Amps Rev H.indd 2 7/13/2017 12:15:14 PM7/13/2017 12:15:14 PM
3
Install a fuse within 18ā (45cm) of the battery and in-line with the power cable connected to your ampliļ¬ er.
If you ever need to remove the ampliļ¬ er from the vehicle after it has been installed, the ground wire should
be the last wire disconnected from the ampliļ¬ er--just the opposite as when you installed it.
POWER WIRING
source unit
high-level speaker
outputs
to ampliļ¬ er
shield
+
ā
core conductor
KICKER KISL (optional)
from source unit high-
level speaker outputs
OR
to ampliļ¬ er
Model External Fuse
(sold separately)
Power/Ground Wire KICKER Wiring Kit
KXA400.2 1 x 60 Ampere 8 Gauge PK8, CK8
KXA400.4 1 x 100 Ampere 4 Gauge PK4, CK4
KXA1200.2 1 x 150 Ampere 4 Gauge PK4, CK4
12V
RADIO
DETECT
OFF/ON
battery
external fuse
remote turn-on
(see page 6)
bare-metal chassis ground
bare-metal
chassis ground
ā¤18ā
(45cm)
ā¤24ā
(60cm)
audio inputs
The KX ampliļ¬ erās RCA inputs will receive either high or low level signals from your car stereoās source
unit. A high-level signal can be run from the source unitās speaker outputs to the stereo RCA input on the
end panel of the ampliļ¬ er using the KICKER KISL as shown. Alternatively, the signal can be delivered to
the ampliļ¬ er using the low-level RCA outputs on the source unit. Keep the audio signal cable away from
factory wiring harnesses and other power wiring. If you need to cross this wiring, cross it at a 90 degree
angle.
2017 KXA Stereo Amps Rev H.indd 32017 KXA Stereo Amps Rev H.indd 3 7/13/2017 12:15:15 PM7/13/2017 12:15:15 PM
Product Specifications
| Brand: | Kicker |
| Category: | Receiver |
| Model: | KXA400.4 |
Do you need help?
If you need help with Kicker KXA400.4, ask a question below and other users will answer you
Receiver Kicker User Manuals
14 October 2024
14 October 2024
14 October 2024
14 October 2024
14 October 2024
14 October 2024
14 October 2024
14 October 2024
14 October 2024
14 October 2024
Receiver User Manuals
- Receiver Sony
- Receiver Bosch
- Receiver Brondi
- Receiver Jensen
- Receiver Hartke
- Receiver Goobay
- Receiver Avantree
- Receiver Cayin
- Receiver Axton
- Receiver Kogan
- Receiver Yamaha
- Receiver Extron
- Receiver Lindy
- Receiver Pioneer
- Receiver NuPrime
- Receiver Ecler
- Receiver AudioControl
- Receiver Rotel
- Receiver Toa
- Receiver Marantz
- Receiver Pyle
- Receiver Wet Sounds
- Receiver JVC
- Receiver VMV
- Receiver S.M.S.L
- Receiver Auna
- Receiver OSD Audio
- Receiver Power Dynamics
- Receiver DataVideo
- Receiver Audizio
- Receiver Vonyx
- Receiver Bluesound
- Receiver Blackstar
- Receiver Cambridge
- Receiver MB Quart
- Receiver Aplic
- Receiver CSL
- Receiver NUVO
- Receiver Block
- Receiver Smart-AVI
- Receiver Advance
- Receiver Artsound
- Receiver Denon
- Receiver Yorkville
- Receiver Valcom
- Receiver Mosconi
- Receiver JBL
- Receiver Helix
- Receiver Soundstream
- Receiver Bellari
- Receiver Rolls
- Receiver Ground Zero
- Receiver Karma
- Receiver Glemm
- Receiver EA
- Receiver Match
- Receiver Renkforce
- Receiver Scansonic
- Receiver SPL
- Receiver Audiotec Fischer
- Receiver Crunch
- Receiver A-NeuVideo
- Receiver ClassƩ
- Receiver FoneStar
- Receiver Monitor Audio
- Receiver Peavey
- Receiver Crown
- Receiver Fosi Audio
- Receiver Graupner
- Receiver Antelope Audio
- Receiver Vaddio
- Receiver ESX
- Receiver Omnitronic
- Receiver Russound
- Receiver MEE Audio
- Receiver GigaBlue
- Receiver Mx Onda
- Receiver Black Hydra
- Receiver Electro-Voice
- Receiver Boss
- Receiver JL Audio
- Receiver Shanling
- Receiver Atlas Sound
- Receiver Ashly
- Receiver Audiolab
- Receiver Memphis Audio
- Receiver AVM
- Receiver Primare
- Receiver PureLink
- Receiver Kramer
- Receiver ATen
- Receiver Blustream
- Receiver Yaesu
- Receiver Musical Fidelity
- Receiver RDL
- Receiver Dynacord
- Receiver Ferguson
- Receiver DAP Audio
- Receiver REL Acoustics
- Receiver Inovonics
- Receiver BZBGear
- Receiver Ram Audio
- Receiver Strong
- Receiver Phoenix Gold
- Receiver HiFi ROSE
- Receiver Intelix
- Receiver Comprehensive
- Receiver Deaf Bonce
- Receiver Fiio
- Receiver Lab Gruppen
- Receiver GlobalSat
- Receiver AVMATRIX
- Receiver Koda
- Receiver Technical Pro
- Receiver Marshall Electronics
- Receiver Naim
- Receiver Anthem
- Receiver Audison
- Receiver Hifonics
- Receiver Geemarc
- Receiver Loxjie
- Receiver Clare Controls
- Receiver Edwards Signaling
- Receiver Hegel
- Receiver August
- Receiver PTN-electronics
Latest Receiver User Manuals
27 October 2024
27 October 2024
27 October 2024
27 October 2024
27 October 2024
27 October 2024
27 October 2024
27 October 2024
27 October 2024
27 October 2024