Sony BKPF-L613C Manual

Sony Not categorized BKPF-L613C

Read below 📖 the manual in Italian for Sony BKPF-L613C (2 pages) in the Not categorized category. This guide has been helpful for 19 people and has been rated 4.5 stars on average by 2 users

Page 1/2
Printed in Japan
BKPF-L613C (SY、和、英) 2009.04 13
3-862-004-06 (1) 1997
SDI DISTRIBUTOR WITH ANALOG MONITOR OUT
BKPF-L613C
INSTALLATION GUIDE (Revised 5)
警告
電気製品安全のためのを守
いと火災や人身事故
ご使用ってンターフェーニッPFV-Lシ
付属のオペンマニュアル「安全のに」をよお読
みください
本機て装着す火災感電他の事故
り、けがした周辺の物品に損害ます
危険けるた装着はサビスレーニングを受け
ご依頼ださい
本機を装着する技術者へ
装着のかたPFV-Lに付属のマニご覧ださ
い。
概要
機は、ンターフェースユニッPFV-L装着て使用す
オプシ基板です1系統の4:2:2シリ
ル信号8系統に分配して出力入力信号波形整形
れて出力EDH(ErrorDetectionandHandling)信号
付加た信号が入力されSDIOUT端は波形整形後
EDH処理信号出力
MONITOROUT各端子か下記の信号出力
1:ンポジト信 Y 号(
スイ
ッチ定)
2:ンポジト信 B-Y信号(内部スッチ定)
3:ンポジト信 R-Y信号(内部スッチ定)
4:ポジト信
仕様
電源 +5VDC1.0A(PFV-L供給)
最大外形寸法 ンボド:267×77mm(幅/高
コネクタ−ル:33×85mm(幅/高
質量 ンボド:150g
コネクタ−パネル:120g
付属品 ンスレ−シンガド(1)
ンスレ−シンマ(1)
仕様び外観改良のめ予告変更す
が、ご了承ださい
Precautions
If this board is installed incorrectly, personal injury or
damage to peripheral items may occur due to fire,
shock, or other accidental circumstances. To avoid
such risks, installation should be performed by trained
service technicians.
To technician installing board
Please refer to the Manual supplied with the PFV-L-
series for installation instructions.
Introduction
This product is an optional board designed to be
installed in a PFV-L-series Interface Unit. The board
divides a 4:2:2 component serial digital signal to eight
lines, and supplies the divided signals. The input
digital video signal is output after its waveform has
been shaped. When a signal including an EDH (Error
Detection and Handling) signal is supplied, the SDI
OUT connectors output the signals after their
waveform have been shaped and after EDH.
Each connector of the MONITOR OUT connectors
outputs the following signals:
1: Composite signal or Y signal
1)
2: Composite signal or B–Y signal
1)
3: Composite signal or R–Y signal
1)
4: Composite signal
1) Selected with an internal switch
Specifications
Power requirements +5 V DC, 1.0 A
(supplied from the PFV-L-series)
Dimensions (w/h) Main board: 267 × 77 mm
(10 3/4 × 3 1/8 inches)
Connector panel: 33 × 85 mm
(1 5/16 × 3 3/8 inches)
Mass Main board: 150 g (5 oz)
Connector panel: 120 g (4 oz)
Supplied accessories Installation Guide (1)
Installation Manual (1)
Design and specifications are subject to change
without notice.
Sony Corporation
For the customers in the U.S.A.
This equipment has been tested and found to comply with
the limits for a Class A digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential
area is likely to cause harmful interference in which case the
user will be required to correct the interference at his own
expense.
You are cautioned that any changes or modifications not
expressly approved in this manual could void your authority
to operate this equipment.
All interface cables used to connect peripherals must be
shielded in order to comply with the limits for a digital device
pursuant to Subpart B of Part 15 of FCC Rules.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation.
For the customers in Canada
This Class A digital apparatus complies with Canadian ICES-
003.
Pour les clients au Canada
Cet appareil numérique de la classe A est conforme à la
norme NMB-003 du Canada.
For the customers in Europe
This product with the CE marking complies with the EMC
Directive issued by the Commission of the European
Community.
Compliance with this directive implies conformity to the
following European standards:
• EN55103-1: Electromagnetic Interference (Emission)
• EN55103-2: Electromagnetic Susceptibility (Immunity)
This product is intended for use in the following
Electromagnetic Environments: E1 (residential), E2
(commercial and light industrial), E3 (urban outdoors), E4
(controlled EMC environment, ex. TV studio).
Pour les clients en Europe
Ce produit portant la marque CE est conforme à la Directive
sur la compatibilité électromagnétique (EMC) émise par la
Commission de la Communauté européenne.
La conformité à cette directive implique la conformité aux
normes européennes suivantes :
• EN55103-1 : Interférences électromagnétiques (émission)
• EN55103-2 : Sensibilité électromagnétique (immunité)
Ce produit est prévu pour être utilisé dans les environnements
électromagnétiques suivants : E1 (résidentiel), E2
(commercial et industrie légère), E3 (urbain extérieur) et E4
(environnement EMC contrôlé, ex. studio de télévision).
Für Kunden in Europa
Dieses Produkt besitzt die CE-Kennzeichnung und erfüllt die
EMV-Richtlinie der EG-Kommission.
Angewandte Normen:
• EN55103-1: Elektromagnetische Verträglichkeit
(Störaussendung)
• EN55103-2: Elektromagnetische Verträglichkeit
(Störfestigkeit)
Für die folgenden elektromagnetischen Umgebungen: E1
(Wohnbereich), E2 (kommerzieller und in beschränktem
Maße industrieller Bereich), E3 (Stadtbereich im Freien) und
E4 (kontrollierter EMV-Bereich, z.B. Fernsehstudio).
For the customers in Europe
The manufacturer of this product is Sony Corporation, 1-7-1
Konan, Minato-ku, Tokyo, Japan.
The Authorized Representative for EMC and product safety
is Sony Deutschland GmbH, Hedelfinger Strasse 61, 70327
Stuttgart, Germany.
Pour les clients en Europe
Le fabricant de ce produit est Sony Corporation, 1-7-1
Konan, Minato-ku, Tokyo, Japon.
Le représentant autorisé pour EMC et la sécurité des
produits est Sony Deutschland GmbH, Hedelfinger Strasse
61, 70327 Stuttgart, Allemagne.
Für Kunden in Europa
Der Hersteller dieses Produkts ist Sony Corporation, 1-7-1
Konan, Minato-ku, Tokyo, Japan.
Der autorisierte Repräsentant für EMV und Produktsicherheit
ist Sony Deutschland GmbH, Hedelfinger Strasse 61, 70327
Stuttgart, Deutschland.

Product Specifications

Brand: Sony
Category: Not categorized
Model: BKPF-L613C

Do you need help?

If you need help with Sony BKPF-L613C, ask a question below and other users will answer you




Not categorized Sony User Manuals

Sony

Sony MVS-6530 Manual

26 October 2024
Sony

Sony MKS-6550 Manual

26 October 2024
Sony

Sony DWR-S02D Manual

24 October 2024
Sony

Sony HDVF-EL100 Manual

24 October 2024
Sony

Sony DWR-S02DN Manual

24 October 2024
Sony

Sony BKPF-L751 Manual

24 October 2024
Sony

Sony CBK-MH01 Manual

24 October 2024
Sony

Sony BKPF-L752 Manual

24 October 2024
Sony

Sony CBK-55AT Manual

24 October 2024
Sony

Sony BKPF-L803 Manual

24 October 2024

Not categorized User Manuals

Latest Not categorized User Manuals