Sony HKDW-102 Manual

Read below 📖 the manual in Italian for Sony HKDW-102 (8 pages) in the Not categorized category. This guide has been helpful for 27 people and has been rated 4.5 stars on average by 2 users

Page 1/8
1
SDTI(HDCAM) INTERFACE BOARD
HKDW-102
OPERATION AND INSTALLATION GUIDE
[Japanese/English]
1st Edition (Revised 3)
HKDW-102 (SY)
3-619-352-04(1)
Printed in Japan
2009.03 13
2002
Sony Corporation
ご使用ってはHDW-2000/M2000/A2100/M2100
属の「オンマニュル 安全のに」をよお読み
ださい
本機て装着す火災感電の他の事故
り、けがした品に害を与するがあす。
危険けるた装着はサレーニングを
ご依頼ださい
本機を装着する技術者へ
装着のかたは、HKDW-102に付属のンスレーンマニュア
ルをごださい
2
For the customers in the USA
This equipment has been tested and found to comply with
the limits for a Class A digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential
area is likely to cause harmful interference in which case the
user will be required to correct the interference at his own
expense.
You are cautioned that any changes or modifications not
expressly approved in this manual could void your authority
to operate this equipment.
All interface cables used to connect peripherals must be
shielded in order to comply with the limits for a digital device
pursuant to Subpart B of Part 15 of FCC Rules.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation.
For customers in Canada
This Class A digital apparatus complies with Canadian ICES-
003.
Pour les utilisateurs au Canada
Cet appareil numérique de la classe A est conforme à la
norme NMB-003 du Canada.
For the customers in Europe
This product with the CE marking complies with the EMC
Directive issued by the Commission of the European
Community.
Compliance with this directive implies conformity to the
following European standards:
EN55103-1: Electromagnetic Interference (Emission)
•EN55103-2: Electromagnetic Susceptibility (Immunity)
This product is intended for use in the following
Electromagnetic Environments: E1 (residential), E2
(commercial and light industrial), E3 (urban outdoors), E4
(controlled EMC environment, ex. TV studio).
The manufacturer of this product is Sony Corporation, 1-7-1
Konan, Minato-ku, Tokyo, Japan.
The Authorized Representative for EMC and product safety
is Sony Deutschland GmbH, Hedelfinger Strasse 61, 70327
Stuttgart, Germany.
Pour les clients en Europe
Ce produit portant la marque CE est conforme à la Directive
sur la compatibilité électromagnétique (EMC) émise par la
Commission de la Communauté européenne.
La conformité à cette directive implique la conformité aux
normes européennes suivantes :
EN55103-1 : Interférences électromagnétiques (émission)
EN55103-2 : Sensibilité électromagnétique (immunité)
Ce produit est prévu pour être utilisé dans les
environnements électromagnétiques suivants : E1
(résidentiel), E2 (commercial et industrie légère), E3 (urbain
extérieur) et E4 (environnement EMC contrôlé, ex. studio de
télévision).
Le fabricant de ce produit est Sony Corporation, 1-7-1
Konan, Minato-ku, Tokyo, Japon.
Le représentant autorisé pour EMC et la sécurité des
produits est Sony Deutschland GmbH, Hedelfinger Strasse
61, 70327 Stuttgart, Allemagne.
Für Kunden in Europa
Dieses Produkt besitzt die CE-Kennzeichnung und erfüllt die
EMV-Richtlinie der EG-Kommission.
Angewandte Normen:
EN55103-1: Elektromagnetische Verträglichkeit
(Störaussendung)
EN55103-2: Elektromagnetische Verträglichkeit
(Störfestigkeit)
Für die folgenden elektromagnetischen Umgebungen: E1
(Wohnbereich), E2 (kommerzieller und in beschränktem
Maße industrieller Bereich), E3 (Stadtbereich im Freien) und
E4 (kontrollierter EMV-Bereich, z.B. Fernsehstudio).
Der Hersteller dieses Produkts ist Sony Corporation, 1-7-1
Konan, Minato-ku, Tokyo, Japan.
Der autorisierte Repräsentant für EMV und Produktsicherheit
ist Sony Deutschland GmbH, Hedelfinger Strasse 61, 70327
Stuttgart, Deutschland.
Warning
This unit must be installed by qualified service
personnel only. Incorrect installation may cause a fire,
electrical shock, or other accident, resulting in
personal injury or property damage.
Note to service personnel installing the
HKDW-102
Refer to the installation manual supplied with the
HKDW-102 for installation instructions.
Avertissement
Cet appareil doit être installé uniquement par un agent
de service qualifié. Une installation incorrecte pourrait
entraîner un incendie, une décharge électrique ou un
autre incident, se traduisant par des blessures ou des
dégâts matériels.
Note au personnel de service installant la
HKDW-102
Consultez le manuel d’installation fourni avec la
HKDW-102 pour les instructions pour l’installation.
Vorsicht
Diese Einheit darf nur von einem qualifizierten
Servicetechniker eingebaut werden. Bei falschem
Einbau droht die Gefahr von Personen- und
Sachschäden durch Brand, Stromschlag oder Unfall.
Hinweis für das für den Einbau der HKDW-102
zuständige Servicepersonal
Näheres zu den Einbauanweisungen finden Sie in der
Einbauanleitung der HKDW-102.
3
概要
SDTI(HDCAM)ンターフェースボ HKDW-102はHD
ルビレコーダ HDW-2000/M2000(以「レコー
ダー」)およびHDデビデオトプレーヤーHDW-A2100/
M2100(以下「プーヤー」)に装着して使用すオプンボドで
す。
本ボードをレコーダー/ーヤー以下のが可能
になます。
HDCAMトの テープ再生信号圧縮デ
SDTI(HDCAM)信号して出ること
他機か入力SDTI(HDCAM)信号伸張圧縮す
となくテープするできます
上記2つの機能画質を劣化せずに編集
こと きま
SDTI(HDCAM)信号は SMPTE 305Mています。
ボードを 装着した HDW-2000/M2000/A2100/M2100は、
格に対していンリ ること ます
取扱いおよび操作に関する情報について
HDW-2000/M2000/A2100/M2100下記のバ以降の
オペンマニュアル(日本語)をご ださい
下記以前のバーンのマニュアルをお持合は、サー
当者ご相談ださい
HDW-2000/M2000
:1stEdition(Revised3)
HDW-A2100/M2100
1stEdition(Revised4)
下は、本ボードをレ / に装着した場合の上記
マニアルに対す補足説明です
SDTI(HDCAM)
出力
SDTI(HDCAM)信号レコーダ / プレ択され
基準信号に同期ーパルのSDTI(HDCAM)
OUTPUT12端子出力
SDTI(HDCAM)
信号出力に関する制約
SDTI(HDCAM)信号出力に関は以下の制限
SD 換テプの挿入時は、SDTI(HDCAM)信出力
せん。
映像は圧縮デ出力のでビデオゲインコロー
ルなどの処理SDTI(HDCAM)出力は反映せん
フリーズ画は SDTI(HDCAM)OUTPUT端子か出力
せん。
HDSDI 入力E-Eで出力していSDTI(HDCAM)
信号は出力せん
プレーヤーは内部テト信 号をSDTI経由で出力すはで
ませ
ご注意
セットアッ の項018「ACTIVELINESELECT」および
項目918「SLOWPROCESSMODE」工場出荷時の設定(OFF)
以外の設定レコーダ/プレのタムコード出
SDTI(HDCAM)出でフしないがあす。
SDTI(HDCAM)出力を編集素材して使用す場合上記2つ
のメニュー項目を工場出荷時の設定に戻ださい
SDTI(HDCAM)
入力の選択、記録、
E-E
モードでの出力
(
レコーダーのみ
)
SDTI(HDCAM)入力を選には、ファンションメュー
HOMEジでF1(VID.IN)「SDTI」に設定
このき、オーディオ 入力自動的 SDTIが選択
ディ 号は、AES/EBU信号同様に録音レベルの調整
びミキシングの設定なが可能です。
SDTI(HDCAM)入力をすると、入力信号がE-E
SDTI(HDCAM)OUTPUT 端子に出れ、伸長れた信号が
HDSDIOUTPUT端子に出力
ただHDCAM圧縮方式のため上記のな場
HDSDI 由で出力るE-E (FrameDTドと )
常にム画す。
ファンクション メニューの1ページ目にあF1(TCG)の
「SDTI」が追加
このメニュー「SDTI」選択す内蔵ムコードジェネレ
ター SDTI(HDCAM)INPUT 端子に入力
SDTI信号に重畳ムコードデ使用すがで
きま

Product Specifications

Brand: Sony
Category: Not categorized
Model: HKDW-102

Do you need help?

If you need help with Sony HKDW-102, ask a question below and other users will answer you




Not categorized Sony User Manuals

Sony

Sony MVS-6530 Manual

26 October 2024
Sony

Sony MKS-6550 Manual

26 October 2024
Sony

Sony DWR-S02D Manual

24 October 2024
Sony

Sony HDVF-EL100 Manual

24 October 2024
Sony

Sony DWR-S02DN Manual

24 October 2024
Sony

Sony BKPF-L751 Manual

24 October 2024
Sony

Sony CBK-MH01 Manual

24 October 2024
Sony

Sony BKPF-L752 Manual

24 October 2024
Sony

Sony CBK-55AT Manual

24 October 2024
Sony

Sony BKPF-L803 Manual

24 October 2024

Not categorized User Manuals

Latest Not categorized User Manuals