Waves MaxxBass Manual
Waves
audio software
MaxxBass
Read below 📖 the manual in Italian for Waves MaxxBass (15 pages) in the audio software category. This guide has been helpful for 23 people and has been rated 4.5 stars on average by 2 users
Page 1/15
MaxxBass
MaxxBass Manual
1
Table of Contents
Chapter 1 QuickStart For MaxxBass............2
Chapter 2 How Does MaxxBass Work..........4
Chapter 3 Controls...................................5
Chapter 4 Mastering With MaxxBass...........7
Benefits .......................... ............. ............. ...........8
Optimizing for better playback on all Speakers...........9
Chapter 5 MaxxBass for Installed Systems...11
Chapter 6 Presets.....................................13
MaxxBass Manual
2
Chapter 1 - Quickstart for MaxxBassâ„¢
Mixing and Mastering
MaxxBass creates harmonics that you can add to the signal. These harmonics trick the ear into perceiving
low bass frequencies that may not actually be present in the output.
This psychoacoustic illusion can be used for mixing and mastering to enhance the bass response for play-
back on any system. MaxxBass can also be used to mix for installed systems, such as commercial sound sys-
tems, theme parks, outdoor distributed systems, personal stereo systems, and more.
For mastering and mixing, simply mix some of the Harmonics into the signal by raising the Harmonics
level fader. You might lower the Original Bass level a few dB as you replace its signal with the MaxxBass sig-
nal. Try to make the mix have the same amount of bass as you normally would, otherwise you run the risk
of over-using the effect, just as you might with any processor in your studio.
Recommended settings to start with for mixing and mastering are the defaults. Simply increase the
Harmonic fader to add to the mix (shown by the yellow curve in the graphic). The best Frequency will be
usually between 60 and 100. Your goal should be a smooth, warm bass response that is balanced, not more
bass than you usually would use.
Using MaxxBass for small speaker systems
This is a special case for MaxxBass. Most people will mix for normal, full-range speaker systems (you want
your mix to sound good everywhere). However, if you are mixing for a specific system, such as a kiosk,
theme park, commercial sound installation, special radio mixes, etc., you can extend the range of that sys-
tem by replacing almost all of the original bass signal with the MaxxBass signal.
Product Specifications
| Brand: | Waves |
| Category: | audio software |
| Model: | MaxxBass |
Do you need help?
If you need help with Waves MaxxBass, ask a question below and other users will answer you
audio software Waves User Manuals
15 October 2024
15 October 2024
15 October 2024
15 October 2024
15 October 2024
15 October 2024
15 October 2024
15 October 2024
15 October 2024
15 October 2024
audio software User Manuals
- audio software TAL Software
- audio software Nugen Audio
- audio software Air
- audio software Antares
- audio software Eventide
- audio software MeldaProduction
- audio software Audio Modeling
- audio software Sonible
- audio software Best Service
- audio software Tek'it Audio
- audio software MAAT
- audio software Dear Reality
- audio software Playfair Audio
- audio software Sound Particles
Latest audio software User Manuals
15 October 2024
15 October 2024
15 October 2024
15 October 2024
15 October 2024
15 October 2024
15 October 2024
15 October 2024
15 October 2024
15 October 2024