Memphis Audio MXAZEQ5BT Manual

Read below đź“– the manual in Italian for Memphis Audio MXAZEQ5BT (6 pages) in the Not categorized category. This guide has been helpful for 39 people and has been rated 4.5 stars on average by 2 users

Page 1/6
65
65
65
65
65
65
65
65
65
65
65
65
65
65
65
65
65
65
65
65
65
65
65
65
65
65
65
65
65
65
65
65
65
65
65
65
65
65
65
65
65
65
65
65
65
65
65
65
65
65
65
65
65
65
65
65
65
65
65
65
MXAZEQ5BT
Dual Zone 5-Band Marine EQ
with Bluetooth
DESIGNED AND DEVELOPED IN THE UNITED STATES, MEMPHIS, TENNESSEE, SINCE 1965
800.489.2300
www.memphisaudio.com
122 Gayoso Ave.
Memphis,TN, USA
@MEMPHISCARAUDIOUSA
@MEMPHISAUDIO
D
E
S
I
G
N
E
D
A
N
D
D
E
V
E
L
O
P
E
D
I
N
T
H
E
U
S
A
|
M
E
M
P
H
I
S
,
T
N
,
U
N
I
T
E
D
S
T
A
T
E
S
,
S
I
N
C
E
1
9
6
5
|
D
E
S
I
G
N
E
D
A
N
D
D
E
V
E
L
O
P
E
D
I
N
T
H
E
U
S
A
|
M
E
M
P
H
I
S
,
T
N
,
U
N
I
T
E
D
S
T
A
T
E
S
,
S
I
N
C
E
1
9
6
5
|
D
E
S
I
G
N
E
D
A
N
D
D
E
V
E
L
O
P
E
D
I
N
T
H
E
U
S
A
|
M
E
M
P
H
I
S
,
T
N
,
U
N
I
T
E
D
S
T
A
T
E
S
,
S
I
N
C
E
1
9
6
5
|
65
65
65
65
65
65
65
65
65
65
65
65
65
65
65
65
65
65
65
65
65
65
Memphis Audio built a 50+ year legacy in the audio industry engineering the highest quality products to produce
the best possible listening experience for our fans and loyal supporters. To fully appreciate our products p2-we
recommend taking the time to read and follow the instructions in this manual. As always, p2-we recommend all
installations and service be performed by an authorized Memphis Audio dealer.
For optimal performance, Memphis recommends using only Memphis Connection accessories. Outfitting
your system with properly sized Memphis Connection wire and accessories will dramatically boost your
listening experience and increase the durability of your Memphis Audio products.
Ready to Turn It Up? Read This First!
Memphis Audio recommends all installations to be performed by an authorized Memphis Audio dealer. If you
chose to proceed with your own installation, please read the following instructions.
• Turn OFF all stereo and other electrical devices prior to beginning the installation
• Disconnect the negative {-} battery lead from your systems battery.
• Locate all fuel lines, brake lines, oil lines and electrical cables when mapping out your installation.
• Check the mounting depth to make sure there is sufficient room to mount the EQ
• When connecting ground points, make certain that all paint is carefully scrapped away from the grounding
location and that the contact is made with bare metal.
• Use a utility knife to trim away fabric from hole locations prior to drilling or cutting. Drilling directly into
fabric can tear and damage fabric beyond the desired installation location.
• When running power cables through sheet metal, be certain to use grommets to insulate the lines from the
metal edges of the sheet metal.
• If possible, use tubing through the grommets for extra protection.
There are two basic mounting options for your MXAZEQ5BT. One is to under-mount the unit beneath the dash
panel using the supplied brackets as shown.
The second option is to flush mount the unit by cutting a hole through a suitable panel for an built-in look. If
you chose the in-dash mounting method, be careful to cut the correct size hole for the best appearance. Also
take care not to let your EQ or the cables interfere with other components in the mounting location.
Installation Instructions
Features
Mounting The Equalizer
Specifications
The MXAZEQ5BT 5-Band marine grade EQ with Bluetooth allows you to dial in your system for peak performance and
control cabin, tower and sub levels from a single unit. The universal 1/2 din design will fit easily in multiple
applications and serve as the command center for your systems audio. This unit is a perfect solution for marine
audio applications.
Main Volume Control With Three Independent Zone Output Controls
Connect up to 3 external amplifiers with separate level output controls from the front panel with a
master volume control for the entire system.
Front Panel Source Selector MAIN/AUX and BLUETOOTH
The front panel source selector control knob allows you to switch between 3 different input sources
(BLUETOOTH, AUX and RCA INPUTS)
5-Band Dual Equalization - Bass, Mid-Bass, Mid and High (BOAT and TOWER)
Each center frequency receives 18dB of boost or cut to adjust
• Bass (75Hz) • Mid Bass (250Hz) • Mids (2kHz) • Mid/High (6kHz) • High (14.5kHz)
USB Charging Port
2 Amp output to charge your connected Bluetooth device.
High Voltage Line Driver
6V of pre-amp signal voltage to deliver clean output signal for your amplifiers. Up to 6V in BLUETOOTH
mode and up to 10V in AUX/MAIN mode.
MOSFET PWM Power Supply
The Pulse Width Modulated power supply is used to provide steady voltage from the vehicles or boats
charging system which can vary under normal operating conditions
Marine Grade Conformal Coated PCB
Conformal coated circuit board resists damage and corrosion from the elements and water.
MXAZEQ5BT
Dual Zone 5-Band Marine EQ
with Bluetooth & Sub Level
Washer
Spring Washer
Washer
Tapping Screw
Spring Washer
Screw
Frequency Response: 10Hz - 50kHz
Frequency EQ Center: 75Hz, 250Hz, 2kHz, 6kHz, 14.5kHz
Total Harmonic Distortion THD: 0.02%
Signal to Noise Ratio: >101dB
Inputs: Switchable, 3-source MAIN, AUX, Bluetooth
Equalization Boost/Cut: -/+18dB
Channel Separation: 85dB
Maximum Output Voltage: MAIN, AUX - 10Vrms @ 0.1%THD | Bluetooth - 6Vrms @0.1%THD
Power Supply: 11-15V DC negative ground
Fuse: 2 Amp (AGC type included)
Dimensions: Chassis 7”W x 1.0”H x 4” D (178mm x 25.4mm x 102mm)
1. Source Input Control Knob - This control will change the input source from MAIN, AUX and Bluetooth
2. Main Volume Control Knob - This control adjusts the output for BOAT, TOWER and SUB.
3. Boat Output Control Knob - This control adjusts the output of the BOAT zone.
4. Tower Output Control Knob - This control adjusts the output of the TOWER zone.
5. Sub Output Control Knob - This control adjusts the output of the SUB zone.
6. Boat Equalizer Control Knobs - These controls will adjust the output at 75Hz, 250Hz, 2KHz, 6KHz, 14.5Hz
from the BOAT output.
7. Tower Equalizer Control Knob - These controls will adjust the output at 75Hz, 250Hz, 2KHz, 6KHz, 14.5Hz
from the TOWER output.
1. USB Charging - Connect your Bluetooth device to charge the battery
2. AUX Input - Connect this 3.5mm input to any second input source (DVD, etc.) This is selected from the input
source control knob.
3. AUX Output - Connect this 3.5mm output to a second EQ, external amp or soundbar. This is a variable output
controlled from the master volume control knob with no EQ adjustments.
4. POWER CONNECTIONS
RED - 12V DC (Constant) - Connect this lead to a 12 volt (+) positive constant source
BLACK - Ground - Connect this lead to a solid ground point
BLUE- Remote Turn On Input - Connect this lead to the remote output of your head unit's remote turn-on
output. If there is no remote output lead or no head unit, connect this lead to a 12V DC switched power
source. This lead turns the EQ on and off.
5. MAIN RCA Input - Connect this to your head unit’s pre-amp output. This is selected from the input source
control knob.
6. Sub RCA Output - Connect this to your mono amplifier’s RCA input connections.
7. Tower RCA Output - Connect this to your tower amplifier’s RCA input connections. This is controlled from the
tower output control knob. Tower EQ controls (outer control knob) will adjust the tone controls from this
output.
8. Boat RCA Output - Connect this to your boat amplifier’s RCA input connections. This is controlled from the
boat output control knob. Boat equalizer control (inner EQ knobs) will adjust the tone controls from this
output.
Controls Rear Panel Connections
1 2 3
4
74
5 6
1
2
3 4 5 6 7 7

Product Specifications

Brand: Memphis Audio
Category: Not categorized
Model: MXAZEQ5BT

Do you need help?

If you need help with Memphis Audio MXAZEQ5BT, ask a question below and other users will answer you




Not categorized Memphis Audio User Manuals

Not categorized User Manuals

Latest Not categorized User Manuals