StarTech.com VDSL-LAN-EXTENDER-1G Manual
StarTech.com
Wifi-repeater
VDSL-LAN-EXTENDER-1G
Read below 📖 the manual in Italian for StarTech.com VDSL-LAN-EXTENDER-1G (2 pages) in the Wifi-repeater category. This guide has been helpful for 25 people and has been rated 4.5 stars on average by 2 users
Page 1/2
Quick-Start Guide
To view manuals, FAQs, videos, drivers, downloads, technical drawings, and more, visit www.startech.com/support.
Manual Revision: October 13, 2023
10/100/1000 Mbps VDSL2 Ethernet Extender Kit - 1km
Product Information
For the latest drivers/software, technical specications, and declarations of
conformance, please visit: www.StarTech.com/VDSL-LAN-EXTENDER-1G
Requirements
• Ethernet Device x 2
• RJ45 Ethernet Cables x 2
• RJ45 or RJ11 Cable x 1
Package Contents
• VDSL Extender x 2
• Mounting Bracket Kits x 2
• Power Supply x 2
• Quick-Start Guide x 1
Installation
(Optional) Mounting the VDSL Extender
Note: Before mounting the VDSL Extender make sure that the surface you are
mounting to is strong enough to support the VDSL Extender. It is recommended that
the VDSL Extender is mounted on a wall stud to provide the correct support.
1. Determine the Mounting Surface for the Local and Remote VDSL Extender.
2. Place the VDSL Extenders upside down to expose the Mounting Bracket Holes on
the VDSL Extenders. Align the Holes in the Mounting Brackets with the Holes on
the bottom of the VDSL Extenders.
3. Insert four Screws through each Mounting Bracket and into the VDSL Extender.
4. Tighten each Screw using a Phillips Head Screwdriver.
5. Mount the VDSL Extender to the desired Mounting Surface using the appropriate
Mounting Hardware (e.g. Wood Screws).
Install the VDSL Extender Kit
1. Position a VDSL Extender in each of the locations, local and remote.
2. Using DIP Switch 1, ensure that one VDSL Extender is in Master Mode (CO), and the
other is in Remote Mode (RT).
Note: If the DIP switches need to be adjusted after the initial setup, both VDSL
Extenders must be powered o before changing the DIP switch settings.
3. Plug in an RJ45 Ethernet Cable from the LAN Port on the local VDSL Extender to an
Ethernet Port on the local Ethernet Device.
4. Plug in an RJ45 Ethernet Cable from the LAN Port on the remote VDSL Extender to
an Ethernet Port on the remote Ethernet Device.
5. Plug in a RJ45 or RJ11 Cable from the VDSL2 Port of the local VDSL Extender, to the
VDSL2 Port of the remote VDSL Extender.
6. Connect the included Power Adapters to each of the VDSL Extenders.
Product ID
VDSL-LAN-EXTENDER-1G
Component Function
1 DIP Switches
• Set the Mode or change settings on the VDSL
Extenders
• Refer to DIP Switch Chart
2 LAN Port
• Connect to an RJ45 Port on Local and Remote
Equipment
3 LAN Status LEDs • Refer to the LED Chart
4 VDSL2 Status LEDS • Refer to the LED Chart
5 VDSL2 Port
• Use a RJ45 or RJ11 Cable to connect the Local
and Remote VDSL Extenders together
6 Power Input Port
• Connect the included Power Adapter
• Located on the rear of each VDSL Extender
2
1 3 4 5
Regulatory Compliance
FCC - Part 15
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment o and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation. Changes or modications not expressly approved by StarTech.com could
void the user’s authority to operate the equipment.
Industry Canada Statement
This Class A digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe [A] est conforme à la norme NMB-003 du Canada.
CAN ICES-3 (A)/NMB-3(A)
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two
conditions:
(1) This device may not cause interference, and (2) This device must accept any interference, including interference that may
cause undesired operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation
est autorisée aux deux conditions suivantes:
(1) l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique
subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.
Warranty Information
This product is backed by a two year warranty.
For further information on product warranty terms and conditions, please refer to www.startech.com/warranty.
Limitation of Liability
In no event shall the liability of StarTech.com Ltd. and StarTech.com USA LLP (or their ocers, directors, employees or agents)
for any damages (whether direct or indirect, special, punitive, incidental, consequential, or otherwise), loss of prots, loss
of business, or any pecuniary loss, arising out of or related to the use of the product exceed the actual price paid for the
product. Some states do not allow the exclusion or limitation of incidental or consequential damages. If such laws apply, the
limitations or exclusions contained in this statement may not apply to you.
Use of Trademarks, Registered Trademarks, and other Protected Names and
Symbols
This manual may make reference to trademarks, registered trademarks, and other protected names and/or symbols of third-
party companies not related in any way to StarTech.com. Where they occur these references are for illustrative purposes only
and do not represent an endorsement of a product or service by StarTech.com, or an endorsement of the product(s) to which
this manual applies by the third-party company in question. StarTech.com hereby acknowledges that all trademarks, registered
trademarks, service marks, and other protected names and/or symbols contained in this manual and related documents are the
property of their respective holders.
FR: startech.com/fr
DE: startech.com/de
ES: startech.com/es
NL: startech.com/nl
IT: startech.com/it
JP: startech.com/jp
StarTech.com
Ltd.
45 Artisans Cres
London, Ontario
N5V 5E9
Canada
StarTech.com Ltd.
Unit B, Pinnacle 15
Gowerton Rd,
Brackmills
Northampton
NN4 7BW
United Kingdom
StarTech.com LLP
4490 South Hamilton
Road
Groveport, Ohio
43125
U.S.A.
StarTech.com Ltd.
Siriusdreef 17-27
2132 WT Hoofddorp
The Netherlands
DIP Switches
Note: The VDSL Extender that is set to Remote mode will always follow the settings set
on the Master VDSL Extender. When set to Remote Mode, DIP Switches 2, 3, and 4 have
no function.
LED Chart
LED Colour Blink On O
PWR Green N/A Powered On Powered O
RT Green N/A RT (Remote) CO (Master)
LNK Green
Slow: Idle
Fast: Training
VDSL2 Link Up
VDSL2 Link
Down
10 Green Data Activity 10Mbps Link Down
100 Green Data Activity 100Mbps Link Down
1000 Green Data Activity 1000Mbps Link Down
VDSL2 Port Pinout
Pin Description
1 N/A
2 N/A
3 N/A
4 Analog Input/Output
5 Analog Input/Output
6 N/A
7 N/A
8 N/A
Product Specifications
| Brand: | StarTech.com |
| Category: | Wifi-repeater |
| Model: | VDSL-LAN-EXTENDER-1G |
Do you need help?
If you need help with StarTech.com VDSL-LAN-EXTENDER-1G, ask a question below and other users will answer you
Wifi-repeater StarTech.com User Manuals
21 October 2024
16 October 2024
Wifi-repeater User Manuals
- Wifi-repeater Xiaomi
- Wifi-repeater Huawei
- Wifi-repeater Fluke
- Wifi-repeater D-Link
- Wifi-repeater Cudy
- Wifi-repeater Extron
- Wifi-repeater Lindy
- Wifi-repeater Netgear
- Wifi-repeater CSL
Latest Wifi-repeater User Manuals
27 October 2024
15 October 2024
15 October 2024
15 October 2024
13 October 2024
13 October 2024
13 October 2024
13 October 2024
13 October 2024
13 October 2024