Generac G0054492 Manual
Read below 📖 the manual in Italian for Generac G0054492 (24 pages) in the Switch category. This guide has been helpful for 26 people and has been rated 4.5 stars on average by 2 users
Page 1/24
www.generac.com or 1-888-GENERAC This manual should remain with the unit.
Owner's Manual
GenReady™ Multi-breaker Load Center and
Transfer Switch
Model Numbers
0054482 GenReady Basic Panelboard NEMA 1
0054492
GenReady Advanced Panelboard with
Operator NEMA 1
0054532 GenReady Basic Panelboard NEMA 3R
0054542
GenReady Advanced Panelboard with
Operator NEMA 3R
Table of Contents
Safety Rules .................................................Inside Front Cover
General Information ................................................................. 2
Introduction ......................................................................................... 2
Equipment Description ......................................................................... 2
Installation Options ............................................................................... 2
Product Options ................................................................................... 2
GenReady Basic Load Center ...................................................... 2
GenReady Advanced Load Center ............................................... 2
EZ Transfer Operator Field Installation Kit ..................................... 3
GenReady Load Center Features ........................................................... 3
Specifications ...................................................................................... 3
Load Center ................................................................................ 3
Transfer Switch Mechanism ........................................................ 4
Transfer Switch Data Decal .................................................................. 4
Panelboard Enclosure ........................................................................... 4
Safe Use Of Transfer Switch ................................................................. 4
Installation ............................................................................... 5
Introduction to Installation ....................................................................5
Unpacking ............................................................................................ 5
Mounting ............................................................................................. 5
Connecting Power Source and Load Lines............................................ 5
Connecting Control Circuit Wires .......................................................... 6
Operation ................................................................................. 6
Functional Tests & Adjustments ............................................................ 6
Manual Operation ................................................................................. 6
Close to Utility Source Side ......................................................... 6
Close to Generator Source Side .................................................. 6
Return to Utility Source Side ....................................................... 6
Voltage Checks ....................................................................................7
Generator Tests Under Load ................................................................. 7
Electrical Automatic Operation Test....................................................... 8
Notes ....................................................................................... 9
Enclosure Mounting Dimensions............................................12
Interconnection Diagrams ......................................................16
SAFETY RULES
SAVE THESE INSTRUCTIONS - This manual
contains important instructions that should be
followed during installation and maintenance of
the generator and batteries.
SAVE THESE INSTRUCTIONS! Read the fol-
lowing information carefully before attempting
to install, operate or service this equipment.
Also read the instructions and information on
tags, decals, and labels that may be affixed to
the transfer switch. Replace any decal or label
that is no longer legible.
DANGER! Connection of a generator to an
electrical system normally supplied by an
electric utility shall be by means of suitable
transfer equipment so as to isolate the elec-
tric system from utility distribution system
when the generator is operating (Article 701
Legally Required Standby Systems or Article
702 Optional Standby Systems, as applicable).
Failure to isolate electric system by these
means may result in damage to generator and
may result in injury or death to utility workers
due to backfeed of electrical energy.
The manufacturer cannot anticipate every possible circumstance
that might involve a hazard. The warnings in this manual, and on
tags and decals affixed to the unit are, therefore, not all-inclusive. If
using a procedure, work method or operating technique the manu-
facturer does not specifically recommend, ensure that it is safe for
others. Also make sure the procedure, work method or operating
technique chosen does not render the transfer switch unsafe.
Throughout this publication, and on tags and decals affixed to the
generator, DANGER, WARNING, CAUTION and NOTE blocks are
used to alert personnel to special instructions about a particular
operation that may be hazardous if performed incorrectly or care-
lessly. Observe them carefully. Their definitions are as follows:
After this heading, read instructions that, if not
strictly complied with, will result in serious
personal injury, including death.
After this heading, read instructions that, if not
strictly complied with, could result in serious
personal injury, including death.
After this heading, read instructions that, if not
strictly complied with, might result in minor or
moderate injury.
For authorized service,
reference the dealer locator
number found inside the
generator owner’s manual.
1
Safety Rules
NOTE:
After this heading, read instructions that, if not strictly complied
with, may result in damage to equipment and/or property.
These safety warnings cannot eliminate the hazards that they
indicate. Common sense and strict compliance with the special
instructions while performing the service are essential to prevent-
ing accidents.
Four commonly used safety symbols accompany the DANGER,
WARNING and CAUTION blocks. The type of information each
indicates follows:
This symbol points out important safety infor-
mation that, if not followed, could endanger
personal safety and/or property.
This symbol points out potential explosion
hazard.
This symbol points out potential fire hazard.
This symbol points out potential electrical
shock hazard.
GENERAL HAZARDS
• Any AC generator that is used for backup power if a UTIL-
ITY (NORMAL) power source failure occurs, must be isolated
from the UTILITY (NORMAL) power source by means of an
approved transfer switch. Failure to properly isolate the UTILITY
(NORMAL) and GENERATOR (STANDBY) power sources from
each other may result in injury or death to electric utility work-
ers, due to backfeed of electrical energy.
• Improper or unauthorized installation, operation, service or
repair of the equipment is extremely dangerous and may result
in death, serious personal injury, or damage to equipment and/
or personal property.
• Extremely high and dangerous power voltages are present
inside an installed transfer switch. Any contact with high voltage
terminals, contacts or wires will result in extremely hazardous,
and possibly LETHAL, electric shock. DO NOT WORK ON THE
TRANSFER SWITCH UNTIL ALL POWER VOLTAGE SUPPLIES
TO THE SWITCH HAVE BEEN POSITIVELY TURNED OFF.
• Competent, qualified personnel should install, operate and ser-
vice this equipment. Adhere strictly to local, state and national
electrical and building codes. When using this equipment,
comply with regulations the National Electrical Code (NEC),
CSA Standard; C22.1 Canadian Electric Code and Occupational
Safety and Health Administration (OSHA) have established.
• Never handle any kind of electrical device while standing
in water, while barefoot, or while hands or feet are wet.
DANGEROUS ELECTRICAL SHOCK MAY RESULT.
• Remove all jewelry (such as rings, watches, bracelets, etc.)
before working on this equipment.
• If work must be done on this equipment while standing on metal
or concrete, place insulative mats over a dry wood platform.
Work on this equipment only while standing on such insulative
mats.
• Never work on this equipment while physically or mentally
fatigued.
• Keep the transfer switch enclosure door closed and bolted at all
times. Only qualified personnel should be permitted access to
the switch interior.
• In case of an accident caused by electric shock, immediately
shut down the source of electrical power. If this is not possible,
attempt to free the victim from the live conductor but AVOID
DIRECT CONTACT WITH THE VICTIM. Use a nonconducting
implement, such as a dry rope or board, to free the victim from
the live conductor. If the victim is unconscious, apply first aid
and get immediate medical help.
• When an automatic transfer switch is installed for a standby
generator set, the generator engine may crank and start at
any time without warning. To avoid possible injury that might
be caused by such sudden start-ups, the system’s automatic
start circuit must be disabled before working on or around the
generator or transfer switch. Then place a “DO NOT OPERATE”
tag on the transfer switch and on the generator. Remove the
Negative (Neg) or (–) battery cable.
Product Specifications
| Brand: | Generac |
| Category: | Switch |
| Model: | G0054492 |
Do you need help?
If you need help with Generac G0054492, ask a question below and other users will answer you
Switch Generac User Manuals
14 October 2024
14 October 2024
14 October 2024
14 October 2024
14 October 2024
14 October 2024
14 October 2024
14 October 2024
14 October 2024
14 October 2024
Switch User Manuals
- Switch Bosch
- Switch IKEA
- Switch Huawei
- Switch HP
- Switch EBERLE
- Switch Lancom
- Switch TP Link
- Switch Totolink
- Switch D-Link
- Switch StarTech.com
- Switch Cudy
- Switch Extron
- Switch Lindy
- Switch Ecler
- Switch Digitus
- Switch LevelOne
- Switch Engenius
- Switch CyberPower
- Switch CSL
- Switch Smart-AVI
- Switch Dahua Technology
- Switch Cambium Networks
- Switch ORNO
- Switch Planet
- Switch PCE
- Switch Equip
- Switch Mikrotik
- Switch Speaka
- Switch Alcatel
- Switch Elation
- Switch Logilink
- Switch Advantech
- Switch Atlona
- Switch Robbe
- Switch Crestron
- Switch IPGARD
- Switch PureLink
- Switch Blustream
- Switch WHALE
- Switch Tenda
- Switch Suevia
- Switch ZyXEL
- Switch Homematic IP
- Switch Setti+
- Switch Trendnet
- Switch Intellinet
- Switch Kaiser
- Switch QNAP
- Switch Rex
- Switch Juniper
Latest Switch User Manuals
27 October 2024
27 October 2024
27 October 2024
27 October 2024
26 October 2024
26 October 2024
26 October 2024
26 October 2024
26 October 2024
26 October 2024