Speco Technologies OSW8T2 Manual

Read below 📖 the manual in Italian for Speco Technologies OSW8T2 (2 pages) in the Not categorized category. This guide has been helpful for 30 people and has been rated 4.5 stars on average by 2 users

Page 1/2
User Manual
IP Encoder
O5E1
Please read this manual carefully before operating the unit and keep it for further reference
Important Safeguards and Warnings
1. Electrical safety
All installation and operation here should conform to local electrical safety codes.
Use a certified/listed 12VDC Class2 or adequate PoE switch.
Improper handling and/or installation could run the risk of fire or electrical shock.
2. Environment
Do not expose the unit to heavy stress, violent vibration or long-term exposure to water and humidity during transportation,
storage, and/or installation.
Do not install near sources of heat.
Only install the product in environments inside the specification operating temperature and humidity range.
Do not install the device near power lines, radar equipment or other electromagnetic radiation.
Do not block any ventilation openings if any.
3. Operation and Daily Maintenance
Please shut down the device and then unplug the power cable before you begin any maintenance work.
Always use the dry soft cloth to clean the device. If there is too much dust, use a cloth dampened with a small quantity of neutral
detergent. Finally use the dry cloth to clean the device.
The grounding holes of the product are recommended to be grounded to further enhance the reliability of the device.
Statement
This guide is for reference only.
Product, manuals, and specifications may be modified without prior notice. Speco Technologies reserves the right to modify these
without notice and without incurring any obligation.
Speco Technologies is not liable for any loss caused by improper operation.
Regulatory Information
FCC conditions:
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
This device may not cause harmful interference.
This device must accept any interference received, including interference that may cause undesired operation.
FCC compliance:
This equipment has been tested and found to comply with the limits for a digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference. This equipment generates uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communication. However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Product Specifications

Brand: Speco Technologies
Category: Not categorized
Model: OSW8T2

Do you need help?

If you need help with Speco Technologies OSW8T2, ask a question below and other users will answer you




Not categorized Speco Technologies User Manuals

Not categorized User Manuals

Latest Not categorized User Manuals